default state when closing the screen on the setup screen.

[renton84uk]

Hi, I currently don’t have access to my NC10, I asked my friend to charge it for me over night (fresh out the box) then just leave it for me. But they decided to turn it on before the green charge light lite.

Seeing the setup screen, they decided they were unable to proceed, at this point the light had turned green.

They unplug the power and closed the lid on the setup screen.

What I am hoping someone where could let me is, would the nc10 go into sleep mode in this situation? or shut down? or would it keep running until it ran out of battery and had to shut down? (so, this is in the initial set-up screen, with the lid closed)

i asked my first how long it was between shutting the lid and the power button going from blue to off, but this proved rather tricky to remember……

I was trying to avoid having to make fully battery cycles, especially the first time the battery is charged from the factory and i am hoping that this hasnt had a really negative effect on the battery life.

Any advice?

Thanks
Renton

[MattJessop]

It’ll be fine, don’t panic. Worst case you will need to plug it in whilst running the first setup and it will charge on it’s own.

[Author]

Posts