Battery Calibration

This topic has 1 reply, 2 voices, and was last updated 12 years, 4 months ago by TJ_1984.

Viewing 2 posts - 1 through 2 (of 2 total)

Author

Posts
December 17, 2008 at 3:53 am #160093

soutthpaw
Member

I noticed in the Bios Setup there is an optiion to run the Battery Calibration. It says that it will discharge battery completely to give a more accurate battery level detection. it only works with Smart Batteries…
Anyone have any experience with this and does the NC10 have a SMART battery?

I did run the program. Now recharging the battery, no idea if it will make the battery usage more accurate or not…
will see tmw if it makes any difference

December 17, 2008 at 10:05 am #175987

TJ_1984
Member

I believe the battery is a SMART battery. I would say though that you probably won’t notice much of a difference regarding accuracy. Of course if you didn’t fully charge the battery in the first place when purchased (12 hours blah blah) then you might see it improves.
Author

Posts

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.